Paxar TC9416CTIUM manual T t i n g t h e P r i n t P o s i t i o n

S e t t i n g t h e P r i n t P o s i t i o n

This function adjusts where data prints vertically on the supply. Adjust the print if it is too close to the top or bottom of the supply, or overtypes the pre-printed area. The adjustments are in dots (0.0049 inch). The range is -99 to +99 and the default is 0.

♦If the data is too close to the bottom, increase the number.

♦If the data is too close to the top, decrease the number.

1 . From the Config Menu, press ← or → until you see

12.Set Print Position

2 . Press Enter. You see

Enter print pos [-99/99] +0

3 . Press ← or → to change the contrast in increments of 1 dot. Press ↑ or ↓ to change the contrast in increments of 10 dots. Pressing ← or ↓ decreases the value (moves the image down);

→or ↑ increases it (moves the image up).

4 . When you are finished, press Enter. You return to the Config Menu.

2-8User Manual