RuggedCom RX1510 manual APE Bios, Resetting the Module, LED Indicators, LED Color and State

Page 37

3. Installation

3.14.5. The APE BIOS

The APE module features a BIOS with functionality similar to that of a typical PC. You can configure the following BIOS settings:

System Time

Processor Options

Boot Options

Security Options

For most purposes, these options are used sparingly unless there is a specific hardware or software requirement that requires a change. The most commonly changed options are the boot options, as the USB ports need to be made bootable to install an operating system.

To display the BIOS menus, press F2 while powering on the APE. To display BIOS help, press F1 and follow the instructions at the bottom of the screen.

3.14.6. Resetting the Module

Whenever possible, shut down and reboot the APE from the operating system instead of performing a hard reset with the reset button. This helps to ensure graceful shutdowns and data integrity. If absolutely required, you can perform a hard reset with the reset button on the APE faceplate.

The reset button is recessed from the front surface of the faceplate. Use a pin or small screwdriver to reach the button.

To reset the APE, depress and hold the reset button until the power LED turns orange. Then, release and push the reset button again. The power LED turns green as the module reboots.

3.14.7. LED Indicators

LED Indicator

LED Color and State

Description

Power LED

Green, steady

APE module is on and functioning correctly.

Power LED

Orange, steady

APE module is not receiving

enough power or is shut down.

 

 

Disk LED

Green, steady or blinking.

Indicates read and write

activity to the solid state drive.

 

 

Ethernet Port LED

Green, steady or blinking.

Indicates incoming and outgoing network activity.

Table 3.13. APE Module LED Indicators

RuggedCom® RuggedBackbone™

37

RX1510 Installation Guide Rev 104

Image 37
Contents RuggedBackbone RX1510 All Rights Reserved Warranty Contacting RuggedComDisclaimer Of Liability Registered TrademarksTable of Contents Page List of Figures Page List of Tables FCC Statement And Cautions Product Overview Feature HighlightsFunctional Overview WAN LM1 through LM4 RuggedBackbone ModulesModule Status LEDs Front PanelPurpose Description Green = OK LM 1 through Orange = Warning alertEthernet Copper Line Modules LMEthernet Fiber WAN SFP ModularSerial Cellular ModemAPE Appplication Processing Engine DDS Digital Data Services27. Pluggable terminal block power module HIP module shown Power SupplyMounting InstallationDIN Rail Mounting Side View 1. RX1510DimensionsRX1510Dimensions Top View Connectors for HI and HIP Power Modules Power Supply Wiring and GroundingConnectors for 24, 24P, 48, and 48P Power Modules Chassis Ground Connection AC Power Supply WiringAC and DC Power Supply Wiring Example DC Power Supply Wiring Examples15. Critical Alarm Relay Connector Critical Alarm WiringSerial Console Port RJ45 Pin Signal FunctionWAN Ports RJ45 T1/E1 pinoutCopper Ethernet Ports WAN Ports BNC1. RJ45 Twisted-Pair Copper Ports Gigabit Ethernet 1000Base-TX Cabling RecommendationsCabling Category 1000Base Required Action Transient SuppressionSerial Ports RJ45 Pin RS232 Mode RS485 Mode RS422 ModeDDS Ports RJ45 RJ45 Pin DescriptionDDS Rx and Tx LED Indications SFP Optics Installation, removal, and precautionsRx LED Color Status Tx LED Color StatusSFP Module Removal Module Insertion SFP25. SFP module removal Fiber Ethernet PortsModule Order Code Description Cellular ModemsGSM, EDGE, HSPA+ Cellular Modem Card Installing SIM Cards for GSM, EDGE, HSPA+ Cellular ModemsPage APE Application Processing Engine Feature DescriptionAPE Overview Supported Operating SystemsPlacing the APE in a Vlan Secondary Network InterfaceProcedure 3.1. To install an operating system Installing an Operating SystemResetting the Module APE BiosLED Indicators LED Color and StateFAQs Power Supply Specifications Technical SpecificationsCritical Alarm Relay Specifications Copper Ethernet Port SpecificationsFast Ethernet 100Mbps Optical Specifications Fiber Ethernet Port SpecificationsCable Tx λ typ Tx min Tx max Distance Power OrderGigabit Ethernet 1Gbps Optical Specifications Mechanical SpecificationsOperating Environment Test Description Test Levels Severity EMI And Environmental Type TestsTest Description Test Levels Ieee 1613 C37.90.x EMI Immunity Type TestsaAgency Standards Comments Agency ApprovalsRuggedCom Inc Warranty