Data is invalid error with no explanation. The new firmware returns an error describing the field containing the error and then returns to the page allowing the error to be corrected.
Command Line Interface
The output of the bridge port summary CLI command has been improved:
■The stpState field has been replaced by Link and Spanning Tree columns to more accurately report the active port status.
■The fwdTransitions field has been renamed
Forward Trans.
■The LACP PartnerID field now reports
LACP disabled if the protocol is disabled or not supported on the port.
The output of the bridge port detail CLI command has been improved:
■The stpState field has been added. This shows if the Spanning Tree Protocol (STP) has been enabled on the port. The field will read Enabled if STP is enabled on the port, even if STP is disabled globally on the unit.
■The currently active spanning tree state for the port is reported in the Spanning Tree column of the VLAN table. Please note that the product supports a single spanning tree state for all VLANs as per the 802.1d Spanning Tree specification. It does not support 802.1s Spanning Tree per VLAN.
Errors and Omissions | 3 |
■The LACP PartnerID field now reports
LACP disabled if the protocol is disabled or not supported on the port.
Traffic Prioritization
In previous versions of the software, the DSCP prioritization of the CS6 code point defaulted to 802.1d priority 7. This has been corrected. The CS6 code point now defaults to 802.1d priority 6.
VLANs
In previous versions of the software, removing a port from a VLAN left static entries bound to the
802.1x Network login authentication:
■In previous versions of the software, authentication attempts for valid users would occasionally fail. The bug causing this has been fixed.
■The user name reported in the CLI command security network access detail was occasionally displayed with incorrect trailing characters. This has been fixed. The user names are now displayed correctly.