3Com 2900 manual

Page 33

zThe selected power module matches that required by the switch.

zThe power cables are properly connected.

zAll the interface cables are cabled indoors. If there is any cable wired outdoors, verify that socket strip with lightning protection and lightning arresters for network ports have been properly connected.

3-11

Image 33

Contents 3Com Baseline Switch 2900 Family Environmental Statement About This Manual OrganizationConventions Related Documentation Obtaining DocumentationManual Description Table of Contents Page Introduction Product OverviewPage Power Supply System 3Com Baseline Switch 2920-SFP PlusFront Panel Rear Panel3Com Baseline Switch 2928-SFP Plus 3Com Baseline Switch 2952-SFP Plus 3Com Baseline Switch 2928-PWR Plus 3Com Baseline Switch 2928-HPWR Plus Ports SpecificationConsole Port 10/100/1000Base-T Ethernet Port1000Base-X SFP Interface Transceiver Central Connector TypeFiber Max Transmis Sion DistancePower LED LEDsRPS Status LED Port Mode LED Port Ethernet port status Switch model Mode Meaning10/100/1000Base-T Auto-Sensing Ethernet Port Status LED LED 1000Base-X SFP Interface Status LED Safety Precautions Installation PreparationsInstallation Site Temperature/HumidityElectromagnetic Susceptibility Laser SafetyDust concentration limit in the equipment room Gas Maximum concentration mg/mInstallation Tools Installing a Switch Introduction to Mounting BracketsModel Mounting bracket Description Attaching the Mounting Brackets to a Switch See -6 , Figure Model Mounting position DescriptionMounting the Switch to a Rack Page Mounting the Switch on a Workbench Connecting the Pgnd CableWhen a Grounding Strip is Available Page Where a Grounding Conductor Can be Buried Other Installation SitesWhen the switch is AC-powered Connecting an AC Power Cord Connecting the Power CordConnecting an RPS DC Power Cord Verifying the InstallationPage Setting Up the Configuration Environment Initial Power-OnConnecting the Console Cable RJ-45 Signal Direction DB-9Connection Procedure Setting Terminal Parameters4Set the serial port used by the HyperTerminal connection 6HyperTerminal window Booting the Switch Checking Before Power-OnPowering On the Switch Describes the fields above 2Description on the fields Enter 9. The system prompts you to change the startup mode Changing the Boot ModeEnter Y. The system displays the following information User interface aux0 is available Press Enter to get started Approaches for Loading Application and Configuration Files Loading Files Through the Boot ROM MenuLoading Software Introduction to the Boot ROM Menu Loading Files Using Xmodem Through Console Port Loading a Boot ROM fileIntroduction to Xmodem Change the rate of the serial port on the terminal Task RemarksDescription Page 2Properties dialog box 5Transfer menu Restoring the download rate to the default Page Introductin to Tftp Loading Files Using Tftp Through Ethernet PortLoad File Name Loading an application file Introduction to FTP Loading Files Using FTP Through Ethernet PortParameters are described in Table 5Description of the FTP parameters Loading an application file Password Loss Maintenance and TroubleshootingUser Password Loss Boot ROM Password LossWith AC power input Power Supply FailureWith RPS power input With both AC and RPS power suppliesConfiguration Terminal Failure Troubleshooting when there is no terminal displayTroubleshooting when the terminal display is illegible