Connection Examples
Important Notes on Placement
•During setup and transport, be careful not to damage the vibrating portions (the speaker cone and diaphragm).
•Be sure to place the monitor so that the slits on the top to radiate the heat is not obstructed. Also, make sure the monitor does not touch any curtains or other fabrics.
•This unit performs cooling when the monitor is placed as shown below. Do not place the monitor on its side or upside down.
Heated Air
•When this unit is in operation, the top side will become hot. Take care not to touch it.
•Do not put anything on the unit.
•During operation, this unit must be placed at a distance of no less than 20 cm from any walls.
no less | no less | |
than 20cm | ||
than 20cm | ||
|
no less | no less |
than 20cm | than 20cm |
*Please also refer to “Placement” in IMPORTANT NOTES (p. 5).
Precautions When Connecting and Turning on the Power
•To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.
•Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. (When turning the power off, reverse this procedure.)
1.Turn on the power on the devices connected to the
2.Turn on the power on the
•This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.
9