Using a Microphone Stand

By using a mic stand, you can mount the CM-30 at the optimal height for use as a monitor speaker or simple PA device.

Requirements when using a mic stand

●As shown in the diagram below, the mic stand’s tripod must be extended to its maximum width (at least 63 cm/25 inches) and the height must be less than 110 cm (including the CM-30).

110 cm (43-5/16”) or less

63 cm (24-13/16”) or more

●Using a mic stand that does not meet the specifications above may result in damage to equipment or injury due to the stand tipping over.

●When using CM-30 with a mic stand, the mic stand must be carefully placed so it is level and sure to remain stable.

●Cables connected to CM-30 should be given enough slack to prevent accidents that might result from someone tripping over them.

●To prevent accidents due to falls, do not place any object on the CM-30 when it’s mounted on a mic stand.

Mounting the CM-30 to a mic stand

Always have at least one other person assist you when mounting the CM-30 on a mic stand, or when adjusting the height of the stand while the CM-30 remains mounted on it.

1.As shown in the diagram, place the CM-30 upside down and rotate the mic stand to screw it firmly into the CM-30’s mic stand holder.

*When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

2.Open the tripod so it’s at full spread.

If the tripod is not fully opened, the stand will be unstable.

3.Grasp the CM-30 and mic stand, and place them upright on the floor.

4.Adjust the height of the mic stand as desired, but do not allow the height (including the CM-30) to exceed 110 cm (approx. 43 inches).

5.Firmly tighten the hardware of the mic stand so that the CM-30 does not wobble to left or right.

*Be careful not to pinch your fingers while performing these steps.