Rosewill RNX-N150HG user manual FCC Statement

Page 2

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

zReorient or relocate the receiving antenna.

zIncrease the separation between the equipment and receiver.

zConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

zConsult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1). This device may not cause harmful interference.

2). This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 2
Contents Wireless High Gain USB Adapter RNX-N150HG FCC Statement National Restrictions 2400.0-2483.5 MHz Country Restriction Reason/remarkConfiguration Guide Package Contents OverviewInstallation Guide WPS ConfigurationPackage Contents Overview of the product FeaturesOverview LED StatusSoftware Installation Installation GuideHardware Installation For Windows XPWireless High Gain USB Adapter RNX-N150HG Wireless High Gain USB Adapter RNX-N150HG Wireless High Gain USB Adapter RNX-N150HG Wireless High Gain USB Adapter RNX-N150HG For Windows Vista Wait a while for the setup as shown in Figure For Windows Wireless High Gain USB Adapter RNX-N150HG Then you will see -19.Click Finish to complete Configuration Guide For Windows XPCurrent Status Profile Management Edit the Security tab Add or Modify a Configuration ProfileEdit the General tab Wireless High Gain USB Adapter RNX-N150HG Edit the Advanced tab Wireless High Gain USB Adapter RNX-N150HG Click Activate Export a Profile Switch another ProfileRemove a profile Import a Profile Scan Available NetworksAuto Profile Selection Management Diagnostics Check Driver Information Check Receive and Transmit Statistical InformationFor Windows Vista 16 Enter Security Key 17 Connecting Click Close to finish For Windows20 Enter Security Key 21 Connecting WPS Configuration PBC Push Button Configuration methodWireless High Gain USB Adapter RNX-N150HG Wireless High Gain USB Adapter RNX-N150HG PIN method Enter a PIN into your AP deviceEnter the PIN from your AP device Wireless High Gain USB Adapter RNX-N150HG Environmental and Physical Appendix a SpecificationsNormal Appendix B Glossary Wireless High Gain USB Adapter RNX-N150HG Appendix C FAQ Wireless USB Adapter does not work properlyNothing happens when I click ‘Open Config Utility’