Wireless High Gain USB Adapter RNX-N150HG

Wireless High Gain USB Adapter RNX-N150HG		User Manual

¾Power Save Mode - Please select the power save mode in the drop-down list.

•Maximum - Selects maximum mode to let the access point buffer incoming messages for the Adapter. The Adapter will detect the access point if any messages are waiting periodically.

•Normal - Normal mode uses maximum when retrieving a large number of packets, then switches back to power save mode after retrieving the packets.

•Off - Turns power saving off, thus powering up the Wireless USB Adapter continuously for a short message response time.

¾Network Type - There are basically two modes of networking:

•Infrastructure - All wireless clients will connect to an access point or wireless router.

•Ad-Hoc - Directly connecting to another computer, for peer-to-peer communication, using wireless network adapters on each computer, such as two or more RNX-N150HG wireless adapters.

)Note:

1)An Infrastructure network contains an Access Point or wireless router. All the wireless devices or clients will connect to the wireless router or access point.

2)An Ad-Hoc network contains only clients, such as laptops with wireless desktop adapters. All the adapters must be in Ad-Hoc mode to communicate.

¾Wireless Mode - Specifies 2.4 GHz 150 Mbps, 2.4 GHz 54 Mbps or 2.4 GHz 11 Mbps operation in an access point network. The Wireless adapter must match the wireless mode of the access point with which it associates.

¾Wireless Mode when Starting an HHAd HocH Network - Specifies 2.4 GHz 54/11 Mbps to start an Ad Hoc network if no matching network name is found after scanning all available modes. This mode also allows the selection of the channel that the Wireless Adapter uses. The channels available depend on the regulatory domain. If the adapter finds no other ad hoc adapters, the channel that the adapter starts the ad hoc network with will be selected automatically. The Adapter must match the wireless mode and channel of the clients it associates.

¾802.11 Authentication Mode - Select which mode the Adapter uses to authenticate to an access point:

•Auto - Automatic causes the adapter to attempt authentication using shared, but switches it to open authentication if shared fails.

•Open - Open System enables an adapter to attempt authentication regardless of its WEP settings. It will only associate with the access point if the WEP keys on both the adapter and the access point match.

•Shared - Shared-key only allows the adapter to associate with access points that have the same WEP key.

For infrastructure (access point) networks, click Preferred APs… to specify four access points at most to the client adapter that attempts to be associated to the access points. The four access points have different priorities; the frontal has the higher priority.