Mode 4 - ABCE Active
& 2 PIN close 2 & 3 PIN close
D
C
E F
B A
Note: There are six SATA ports in Serial ATA
Hardware Installation
1.Turn Off the power to your computer and any other connected peripheral devices.
2.Unplug the power cord form the back of the computer.
3.Remove your computer’s cover.
4.Remove the slot bracket from an available PCI slot.
5.To install the card, carefully align the card’s bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.
6.Replace the slot bracket’s holding screw to secure the card.
Device Connection
The Serial ATA
1.Install your hard disk drive(s) in chassis.
2.Connect the Serial ATA hard disk drive to the system power supply using the included Serial ATA power cable.
3.Connect one end of the Serial ATA cable to the hard disk drive.
4.Attach the other end of the Serial ATA cable to the Serial ATA controller on the Serial ATA
5.Follow the same instructions to connect up to four hard drives. Device connection is now complete.
6.Replace the computer cover and reconnect the power cord.