Roland DIF-AT24 owner manual Connecting the VS-2400CD with an Adat device and BRC

Page 13

Connections and settings

Connection example 4

Connecting the VS-2400CD with an ADAT device and BRC

The BRC is used to operate the VS-2400CD and ADAT device in synchronization. Make connections as shown in the diagram.

To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

BRC

ADAT device

MIDI OUT		ADAT OPTICAL IN								ADAT OPTICAL OUT

	ADAT
MIDI IN	OUT	ADAT IN

DIF-AT24

R-BUS

R-BUS

VS-2400CD

13

Image 13

Contents Congratulations on your purchase of the Roland DIF-AT24 Main FeaturesCopyright 2003 Roland Corporation Page Avis Placement Power SupplyMaintenance Additional PrecautionsContents Front Panel Panel descriptionsRear Panel These are used mainly for MTC synchronizationTurning the power on Turning the power on/offTurning the power off Connecting the VS-2400CD and a computer Connections and settingsMaster Clock settings Sampling Frequency settingsSynchronization settings Set the VS-2400CDs parameters as follows MMC settingsAdat Optical Adat Optical OUT Sync Parameter screen YNC Parameter screen Connecting the VS-2400CD and an Adat device Connecting the VS-2400CD with an Adat device and BRC Set the VS-2400CDs parameters as follows BRC settingsMake connections as shown in the diagram MV-8000 settingsInformation VM-7100/7200 と接続する場合