Roland DIF-AT24 owner manual BRC settings, Set the VS-2400CDs parameters as follows

Connections and settings

Settings

■Sampling Frequency settings

Set the sampling frequency of the VS-2400CD and ADAT device to the same setting (48 kHz).

■Master Clock settings

Master clock device	VS-2400CD setting		DIF-AT24
			MASTER CLK switch
VS-2400CD	PROJECT PARAMETER screen		R-BUS
	❍ MASTER CLOCL	INT
ADAT device	PROJECT PARAMETER screen		ADAT
	❍ MASTER CLOCL	R-BUS

You'll also need to set the Master Clock for the ADAT device. For details on this setting, refer to the owner's manual for the ADAT device.

■Synchronization settings

Set the VS-2400CD's parameters as follows.

MIDI PARAMETER screen

❍SysEx. Rx. Sw. On

❍MMC MODE.. SLAVE

❍MMC SOURCER-BUS

SYNC PARAMETER screen

❍SYNC MODE . EXT

❍EXT SYNC SOURCER-BUS

❍FRAME RATE..................... Same setting as the software.*

■BRC settings

1

2

3

Press [EDIT] ➔ [GEN SYNC] ➔ [GEN SYNC].

The screen will indicate “Generate Sync.”

Use [▲][▼] to select “MIDI: MTC,” and press [EDIT].

[EDIT] will go dark.

Press [GEN SYNC].

[GEN SYNC] will light, and the BRC will output MTC.

14