Roland DIF-AT24 owner manual Connections and settings, Connecting the VS-2400CD and a computer

Page 8

Connections and settings

Connection example 1

Connecting the VS-2400CD and a computer

Here's an example of synchronization with computer-based sequencer software or the VS-2400CD functioning as the master.

Make connections as shown in the diagram. This example uses the UA-1000 to perform input/output with the computer via USB 2.0.

To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

PC

USB 2.0 connector

USB

UA-1000

MIDI IN								MIDI OUT OPTICAL IN
MIDI IN								MIDI OUT OPTICAL IN

						ADAT
MIDI IN						ADAT
MIDI IN						OUT

MIDI OUT

R-BUS

VS-2400CD

OPTICAL OUT

ADAT IN

DIF-AT24

R-BUS

8

Image 8

Contents Copyright 2003 Roland Corporation Main FeaturesCongratulations on your purchase of the Roland DIF-AT24 Page Avis Power Supply PlacementMaintenance Additional PrecautionsContents Panel descriptions Front PanelRear Panel These are used mainly for MTC synchronizationTurning the power off Turning the power on/offTurning the power on Connections and settings Connecting the VS-2400CD and a computerSampling Frequency settings Master Clock settingsSynchronization settings Set the VS-2400CDs parameters as follows MMC settingsAdat Optical Adat Optical OUT Sync Parameter screen YNC Parameter screen Connecting the VS-2400CD and an Adat device Connecting the VS-2400CD with an Adat device and BRC BRC settings Set the VS-2400CDs parameters as followsMV-8000 settings Make connections as shown in the diagramInformation VM-7100/7200 と接続する場合