Rolls RPM26 owner manual Introduction, Description, Installation, Specifications

Page 2

INTRODUCTION

Thank you for your purchase of the ROLLS RPM26 Rack Power Module. The

RPM26 is a single rack space power distibution unit with eight rear-panel AC

outlets, and an individually switched outlet on the front panel. The RPM26 fea-

tures front-panel lighting in the form of brilliant white LED light. A Dimmer control

adjusts the brightness of the LEDS. Because of the low voltage and high efficien-

cy of these LEDs, they will likely never need replacing. An added feature is the

inclusion of a front panel 12VDC BNC connector to power external or gooseneck

type lights

Please read the following manual carefully to achieve the best results from this product.

DESCRIPTION

FRONT PANEL

Switched Outlet: AC outlet.

Switch - Turns the Switched Outlet on and off.

Dimmer: Adjusts the brightness of the white LED lights.

12VDC: BNC connector for optional 12 volt lighting.

Power: Main power switch - Turns ALL outlets on and off.

REAR PANEL

100 - 220 VAC 50/60 HZ 10 VA: IEC Power Cord. Connect to a properly ground-

ed AC source. NOTE: REPLACE THE FUSE WITH ONLY THE PROPER RATED FUSE. INSTALLING A FUSE OTHER THAN THE RECOMMENDED RATING WILL DAMAGE THE UNIT.

POWER OUTLETS: 8 ea; AC outlets. Rated for 8 amps maximum each.

INSTALLATION

Mount the RPM26 in a safe and sturdy rack. Connect the IEC power cable to the RPM26, and to a properly grounded AC outlet.

Connect the power cables from your devices to the power outlets on the rear of the RPM26.

Audio Device Warning

It is recommended that power amplifiers be switched OFF separate from the RPM26 - to avoid power surges and possible damage to speakers (and your ears). Switch power amplifiers off first before switching off the RPM26, and switch the power amplifier on after the RPM26.

SPECIFICATIONS

 

AC Outlets:

9 ea; 8 rear panel, 1 front panel

Switches:

2 rocker type

Control:

1 variable Dimmer control

12VDC Out:

BNC female connector / 250mA Max.

Voltage Regulation:

None

Power:

100 - 230 VAC 50/60 Hz, 10A Max.

Size (W x H x D):

19” x 1.75” x 5” (48 x 4.5 x 12.7)

Weight:

5.5 lbs (2.5 kg)

Image 2
Contents PM26 Rack Power ModuleLimited Warranty Introduction InstallationSpecifications Description