RTS DSI 2008 manual Specifications, Wire Ports

Page 8

Specifications

2-Wire Ports

Input / Output Impedance 5,000 ohms, nominal

Operating Level

Audiocom: 1 VRMS, nominal

RTSTW/ClearCom: 775 mVRMS, nominal

4-Wire Ports

Input Impedance 10k ohms, nominal

Output Impedance

200ohms

Operating Levels

-10 dBu, 0 dBu, +4 dBu, +8 dBu, +12 dBu

System to System

Frequency Response

200 Hz to 3.5 kHz, ±4 dB

THD: 1% @ channel output with nominal input

Environmental

Operating Temp

-20°C to 50°C (-4°F to 122°F) Storage Temp

-40°C to 85°C (-40°F to 185°F) Humidity

0 to 95%, non-condensing

Main Voltage

100 to 250 VAC, 50/60 Hz

Dimensions

1.72” (44mm) High x 8.19” (208mm) Wide x 8.0” (204mm) deep

Weight

5.0lbs (2.3kg)

Finish

Thermoplastic front panel, aluminum case, light gray finish

Approvals

UL, CSA, UDE, CD

Specifications subject to change without notice.

4

Image 8
Contents User Instructions DSI 2008 Digital System Interface ADAM, Adam CS, and Zeus IntercomsSee the enclosed warranty card for further details Contents Page Features General DescriptionFront and Back Panel Descriptions Front PanelBack Panel Specifications Wire PortsADAM, ADAM-CS, or Zeus Audio Connection Wire Audio ConnectionsMounting Pin Connection Connector Type 9-pin male D-subminiature RJ-11 Connection Connector Type RJ-11 plugRack Mount Configurations RTS TW Audio ConnectionsUsing a TW-5W to connect to two TW channels to the DSI Audiocom Audio ConnectionOther 2-wire Audio Connection Balanced ConfigurationUnbalanced Configuration Clear-Com Audio ConnectionWire Call Signal Connections Call Signal Connection for ADAM, Adam CS, and ZeusPin No Function GPI Input NUMBERSa UIO-256 Frame Common Input Height 18 VDCUIO-256 Wire Call Send and Call Enable/InhibitGPI Output Numbers a Wire Call Receive Wire Call SignalCall Signal Connections for Audiocom, RTS TW and Clear-Com Balanced Audio Configuration Page Operation General InstructionsOperating Notes for ADAM, Adam CS and Zeus Intercom Systems Access and Configuration Internal AccessMode Dip Switch Settings U301 Switch Settings DescriptionFull-Duplex Definition Half-Duplex DefinitionCall Signal Option Card Installation Call Signal Option Card after installation in the DSI