Panduit LS3E manual Or stopping at next label Loaded on mandrel, and side

Labels not registering properly,	Labels are not loaded properly.	Make sure labels are properly
or stopping at next label.		loaded on mandrel, and side
		guides are positioned correctly.
		Labels should be located as far
		to right as possible.
		Make sure printhead is
		located in the center of the
		printer.
	Sensor is dirty.	Carefully clean registration
		sensor located to the right side
		of drive roller by blowing on
		the opening of the sensor.
Not printing.	Printer is not ready to operate.	Make sure printer:
		1. Is turned on.
		2. Has ribbon cartridge
		properly loaded.
Print is smudged or too dark.	Ribbon is not loaded correctly.	Load ribbon properly between
		the printhead and print shield.
	Drive roller or print shield is	Remove ribbon cartridge, and
	dirty.	carefully clean drive roller,
		print shield, and print
		mechanism assembly with
		isopropyl alcohol and cotton
		swab.
Print dots missing or light.	Ribbon problem.	Make sure ribbon is properly
		installed between the
		printhead and print shield, and
		ribbon manual advance knob is
		spinning during printing.
		Ribbon is worn. Replace ribbon.
		Ribbon not advancing.
		Remove cartridge from
		printer, and make sure ribbon
		can be advanced by turning
		knob on ribbon cartridge
		counter-clockwise. Install
		ribbon properly.
	Drive roller is not seated	Make sure drive roller is not
	properly.	skewed and is firmly
		supporting the label stock.
	Printhead has broken pin or	Contact Panduit Technical Ser-
	blown solenoid (visible if a	vice at (888)506-5400
	portion of the line of text is	extension 7470.
	missing).

23