Wiring the DC Input Power Source

Panduit Catalyst 3550 warranty Wiring the DC Input Power Source

Page 18

Step 3 Slide the exposed area of the 6-gauge wire into the ground lug, and use the crimping tool to crimp the lug to the wire.

Step 4 Using the ratcheting screwdriver, torque the ground lug screws to 15 lbf-in. (240 ounce-force inches [ozf-in.]) to attach the ground lug to the switch.

Follow these steps:

Step 1	On the terminal block connector, identify the positive and negative feed positions.
Step 2	Strip each of the four wires coming from the
	DC power source to 0.27 inch (6.6 mm)
	0.02 inch (0.5 mm). Do not strip more than	0.27 inch (6.6 mm)
	the recommended amount of wire.

Step 3 Insert the four exposed wires from the DC-input power source into the terminal block plug, matching positive to positive and negative to negative for both the A and the B feed wires.

Image 18

Contents

Panduit Catalyst 3550 warranty Wiring the DC Input Power Source

Wiring the DC Input Power Source