Samsung HT-H4500 ĞĞ Automatic, ĞĞ Manual, Enter the IP Address, Subnet Mask, and Gateway values

!! Before you begin, confirm that the product is connected to your router with a network cable.

ĞĞAutomatic

To start the configuration process, follow these steps:

1.In the Home menu, select Settings, and then press the v button.

2.Select Network, and then press the v button.

3.Select Wired Network Settings, and then press the v button.

The Wired Network Settings screen appears.

4.Press the + button on the Internet Protocol Setup menu.

Use $% button to select Auto, and then press the v button.

Settings
Display	Wired Network Settings
AudioInternet Protocol Setup		: Auto
NetworkIP Address		:	0	0	0	0
SystemSubnet Mask		:	0	0	0	0
Gateway		:	0	0	0	0
Language
SecurityDNS		: Auto
DNS Server		:	0	0	0	0
General
Support		> Move		" Select		' Return

5.The Network function acquires and fills in the values for IP Address, Subnet Mask, etc., automatically.

6.After the Network function has acquired the network values, press the RETURN button.

7.Select Network Test, and then press v. The home theater validates the network connection. When it is done, press the RETURN button.

ĞĞManual

If you have a static IP address or the Automatic procedure does not work, you’ll need to set the Network Settings values manually. You can get the Network Settings from your Internet Service Provider (ISP).

Settings
Display	Wired Network Settings
AudioInternet Protocol Setup		: Manual
NetworkIP Address		:	0	0	0	0
SystemSubnet Mask		: 255		255	255	0
Gateway		:	0	0	0	0
Language
SecurityDNS		: Manual
DNS Server		:	0	0	0	0
General
Support		> Move		" Select		' Return

1.Follow the first four steps in the Automatic procedure, but select Manual instead of Auto in Step 4.

2.Press the ▼ button to go to the first entry field (IP Address).

3.Use the number buttons on your remote to enter numbers.

4.When done with each field, use the ▶ button to move successively to the next field.

You can also use the other arrow buttons to move up, down, and back.

5.Enter the IP Address, Subnet Mask, and Gateway values.

6.Press the ▼ button to go to DNS.

7.Press the ▼ button to go to the first DNS entry field. Enter the numbers as above.

8.Press the Return button on your remote.

9.Select Network Test, and then press v. When the test is completed, press the Return button to exit to the previous screen.

10.Select Network Status, and then press v.

11.The Network Status screen appears.

The product verifies the network connection and then connects to the network. When it is done, highlight OK, and then press v.

Settings

17 - English