Planet Technology Troubleshooting, Can the POE-151 work with Gigabit Ethernet device?

Page 9

3.TROUBLESHOOTING

This chapter contains information to help you solve problems. If the Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual.

The PoE LED is not lit

Solution:

Check the cable connection between POE-151 and IEEE 802.3af device.

Can the POE-151 work with Gigabit Ethernet device?

Solution:

The POE-151 use 4-wire for data transmission (pair 1, 2, pair 3, 6) and 4-wire for power supply (pair 4, 5, pair 7, 8), thus Gigabit Ethernet device connect to POE-151 will not send data over the power wire and the transmit speed shall change to 100Mbps.

Why I connect my PoE device to POE-151 and it cannot power on?

Solution:

1. Please check the cable type of the connection from POE-151 to the other end. The cable should be an 8-wire UTP, Category 5 or above, EIA568 cable within 100 meters. A cable with only

4-wire, short loop or over 100 meters, all will affect the power supply.

2.Please check and assure the device that fully complied with IEEE 802.3af standard.

- 9 -

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Page Disclaimer TrademarksFCC Warning CE Mark Warning RevisionTable of Contents About the Power over Ethernet Injector ChecklistFeatures IntroductionProduct Outlook SpecificationBefore Installation Hardware InstallationFrom POE-151 or Ieee 802.3af Power Supply equipment POE-151, the Injector installationConnection architecture over POE-151/151S Connect with Ieee 802.3af devicesCan the POE-151 work with Gigabit Ethernet device? TroubleshootingSwitch‘s RJ-45 Pin Assignments Appendix a Networking ConnectionRJ-45 cable pin assignment
Top Page Image Contents