Samsung HT-DS610 instruction manual Insert Remote Batteries

1p~42p(DS610)-SEA 9/15/04 2:46 PM Page 15

Insert Remote Batteries

1 Remove the battery cover on the back of the remote by pressing down and sliding the cover in the direction of the arrow.

2 Insert two 1.5V AAA

batteries, paying attention to the correct polarities (+ and –).

3 Replace the battery cover.

PREPARATION

Caution Follow these precautions to avoid leaking or cracking cells:

• Place batteries in the remote control so they match the polarity:(+) to (+)and (–)to (–).

•Use the correct type of batteries.Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

Range of Operation of the Remote Control

The remote control can be used up to approximately 23 feet/7 meters in a straight line. It can also be operated at a horizontal angle of up to 30° from the remote control sensor.

To open the remote control cover, push the top of the cover, then slide downward.

12