Quantum Travan 40 GB manual Hard Disc

Page 15

Installing the Drive

Installation Procedure

Figure 8 Use a Mew

40-Pin IDE Cable

ComputerMotherboard

Primary

IDE port

Secondary

IDE port

Hard

Disc

TAPE

Stripe on cable

Pin 1 (typical)

Figure 9 4-Pin Power Cable Connection

In either case, make sure that pin 1 on the tape drive (located next to the power connector) is connected to pin 1 on the IDE cable and on the IDE port connector. Pin 1 on the IDE cable is indicated by a stripe on the edge of the cable.

6Connect the power cable

Connect a 4-pin power cable to the back of the tape drive (see figure 9). If all the power cables in your computer are being used by other devices, you can purchase a Y-shaped power-cable splitter from your computer dealer.

Quantum Travan 40 GB Internal Storage System

11

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 7UDYDQ Copyright Statement Contents Chapter Troubleshooting About This Manual 1IntroductionAbout Your Travan Tape Drive 2Installing the Drive Important PrecautionsWhat You Will Need Installation Procedure Disc ROM Disc Second Atapi Device Configured for Cable Select You may have to remove the mounting brackets ROM Hard Disc Using The Tape Drive Loading and Unloading Cartridges 3Operation and MaintenanceTo Load a Cartridge Handling Travan CartridgesWrite- Protect Feature Setting the Write-Protect SwitchRetensioning Tapes Cleaning the Tape Drive MechanismTape Frame Capacity Length Recommended Tape CartridgesPage Installation troubleshooting 4TroubleshootingTroubleshooting Tape Operations Troubleshooting Tape Operations TroubleshootingADisposal of Electrical and Electronic Equipment Quantum Travan 40 GB Internal Storage System
Top Page Image Contents