Samsung HT-DS400 Setting the Test Tone, Press Menu ‘Audio’ and then, Press Test Tone button

41P~74P(DS400)-SECA GB 11/10/04 9:16 AM Page 53

Setting the Test Tone

Use the Test Tone feature to check the speaker connections and to adjust the speaker levels.

In Stop mode,		Press Cursor		Press Cursor button
		button to move to		to move to ‘TEST
press MENU
		‘Audio’ and then		TONE’ and then press
1 button.	2		3
		press ENTER button.		ENTER button.

• The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in that order.

If the ENTER button is pressed again at this time, the test tone will stop.

Press RETURN button to return to the previous level.

Press MENU button to exit the setup screen.

SETUP

Alternate method: press the TEST TONE button on the remote.

Press TEST TONE button.

•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

To end the test tone,

press TEST TONE button again.

L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
R: Front Speaker (R)	LS: Rear Speaker (L)	RS: Rear Speaker (R)

Multi-Channel Pro Logic Mode

Start

54