StorCase Technology DX115 manual Installing the Receiving Frame, Receiving Frame Mounting Holes

Page 17

10

Installation

Installing the Receiving Frame

NOTE: Use a #2 Phillips screwdriver for this procedure.

The drive should be installed into the carrier before installing the receiving frame into the mounting bay of a computer or expansion chassis.

1.Turn OFF power to the computer.

2.Open the computer system according to the manufacturer’s instructions. If neces- sary, temporarily remove any expansion boards that may make installation difficult.

3.With the drive carrier locked in place inside the receiving frame, install the DX115 into the 5.25” drive opening in the computer or expansion chassis. Use the appro- priate guides to position the Data Express, and fasten it into place with the four

(4) M3 Phillips screws provided. Figure 7 illustrates the location of the mounting holes. Mounting holes are provided on each side and the bottom of the receiving frame to accommodate a variety of mounting configurations. Use the mounting holes which best suit the computer or expansion chassis configuration. Note that bottom mounting holes require self-tapping screws (not provided).

4.Adjust the front of the receiving frame so the carrier slides freely in and out on the receiving frame guides. The position of adjoining peripheral units may require ad- justment.

Mounting

Holes

(Bottom)

Mounting

Holes

(Left)

Mounting

Holes

(Right)

Figure 7: Receiving Frame Mounting Holes

StorCase Technology, Inc.

DX115 for Backup User's Guide - Rev. A01

Image 17
Contents Data Express DX115 for Backup Fax 714 Part No. D89-0000-0306 A01 JuneStorCase Technology, Inc Newhope Street Fountain Valley, CA Duration of Warranty Limited WarrantyFree Technical Support Warranty Claim RequirementsDeclaration of Conformity Table of Contents Sata 3Gbps DX115 Receiving Frame and Carrier List of FiguresReceiving Frame Device Carrier Packaging InformationSerial Numbers Package Contents Sata 3Gbps DX115 Receiving Frame and Carrier General DescriptionFront Panel Front PanelDrive Ready Blue Power Switch contdError Red Fan Receiving Frame Rear PanelPreparation Installing the Drive into the Drive CarrierDrive Installation Assembly Drive Cover Installation Receiving Frame Mounting Holes Installing the Receiving FrameDrive Activity LED Drive Hot Swap Data Backup and Restoration Removing the Cooling Fan Replacing the Cooling FanAppendices Specifications and dimensions below are for reference only Appendix a Specifications/DimensionsReceiving Frame with Carrier Installed Carrying Case Appendix B Optional AccessoriesReaders Comments Business Reply Mail