Connecting the Wireless Receiving Amplifier

connections

Connecting the Wireless Receiving Amplifier

1. Connect the front, center and Subwoofer speakers to the DVD Player, refering to page 21.

. With the DVD Player turned off, insert the TX card into the TX Card Connection(WIRELESS) on the back of the main unit.

~Hold the TX card so that the slanted side faces to the left and insert the card into the port.

~The TX card enables communication between the main unit and the wireless receiver.

3. Connect the left and right rear speakers to the wireless

receiving module.

Slanted side face left

TX card

. Plug the power cord of the wireless receiving module in the wall outlet and switch the power switch ON.

M ` Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main unit, some sound interruption may be heard due to interference.

`If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (5.8GHz) near the system, some sound interruption may be heard due to interference.

`The transmission distance from the main unit to the wireless receiving module is about 33 feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

`This product(HT-Z510/HT-TZ512) is also compatible with the wireless receiver module SWA-3000.

`If the main unit doesn't make wireless connection, the system needs ID Setting between main unit and wireless receiver module. With the main unit turned off, press remote control's number button "0""1""3""5" and unit turned on. With the wireless receiver module turned on, press "ID SET" button on the back of the unit for 5 seconds.

` Do not insert any other card except the TX card dedicated to the product.

If a different TX card is used, the product may be damaged or the card may not be removed easily.

`Do not insert the TX card upside down or in the reverse direction.

`Insert the TX card when the DVD Player is turned off. Inserting the card when it is turned on may cause a problem.

`If the TX Card is inserted and wireless receiving module setting is complete, sound is not output from the Rear Speaker connectors on the main unit.

`The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.

`For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

`If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1 channel or Dolby ProLogic II .

24` In 2-CH mode, no sound will be heard from the wireless rear speakers.