SMC Networks ST40 manual Troubleshooting, Symptom, Probable Causes, Possible Solutions

Page 21

TROUBLESHOOTING

1.Symptom

Power LED does not light after power on.

Probable Causes

Power outlet or power cord may be defective.

Possible Solutions

•Check for loose connections.

•Check the power outlet by using it for another device.

•Replace the power cord.

2.Symptom

Link LED does not light after connection is made.

Probable Causes

Switch port, network card or cable may be defective.

Possible Solutions

•Check that the switch and attached device are both powered on.

•Be sure the network cable is connected to both devices.

•Verify that Category 5 cable is used for 100 Mps connections and that the length of any cable does not exceed 100 meters

(328 feet).Check the network card and cable connections for defects.

•Replace the defective card or cable if necessary.

9

Image 21

Contents EZ Switch 10/100 Page EZ Switch 10/100 User Guide Trademarks CopyrightLimited Warranty Limited Warranty FCC Class a CompliancesIndustry Canada Class a Japan Vcci Class aEC Conformance Declaration Class a Safety Compliance Australia AS/NZS 3548 1995 Class aUnderwriters Laboratories Compliance Statement Wichtige Sicherheitshinweise Germany Table of Contents Viii Features and Benefits About the EZ Switch 10/100LED Front Panel LEDsFDX Rear PanelEquipment Checklist Installing the SwitchSelecting a Site Instructions Standalone LAN Sample ApplicationsHigh-Speed Switch Links Symptom TroubleshootingPossible Solutions Probable CausesCable Specifications CablesTwisted-Pair Cable and Pin Assignments 10BASE-T/100BASE-TX Pin Assignments 100BASE-TX Connectivity GuidelinesEZ Switch 10/100 SpecificationsTemperature WeightPower Requirements Power ConsumptionPage Internet