QVS CS12 manual Installation

Page 9

Installation

Before you begin, make sure that power to all the devices (Master View CS-12 and both PCs) you will be connecting up have been turned off.

1.Plug the monitor, keyboard, and mouse into the Console port connectors of the Master View CS-12 unit.

2.Use the extender cables (as described in the Hardware Requirements and Unpacking sections ), to connect the monitor, keyboard and mouse ports of the PCs to the Master View CS-12 CPU Ports, as shown in the diagram below.

Note: If your PCs use AT style connectors for the keyboard and mouse ports, refer back to the note in the Cables Section on p.3.

4.Turn on the power to the connected PCs.

7

Image 9
Contents Manual Part No. PAPE-1143-100 Table of Contents Overview Features Hardware Requirements ConsoleCables Unpacking Top View Console View CPU Port ViewInstallation Operation Manual Port SelectionHot Key Port Selection Auto Scan Mode Last/Next ModeSelecting the Active Port Page Troubleshooting AppendixSelected LED Display Specifications Radio & TV Interference Statement Limited Warranty