Xantech HD44CC5 installation instructions CAT5 Zone Output, Coaxial Zone Output

[9] CAT5 ZONE OUTPUT

Output connection to the HDRXSG01 receiver module. Uses standard CAT5 cable. Be sure to verify CAT5 wiring connection is correct before installation.

[10] COAXIAL ZONE OUTPUT

Gold-plated RCA jacks for connection to an HD monitor. Color coordinated to match all HD type products. The CAT5 and coaxial output can be used at the same time.

IMPORTANT NOTICE

After connecting the CAT5 cable to the receiver (HDRXSG01), the power supply to the receiver should be unplugged for a few seconds and then reconnected. This allows the receiver to go through the full process of line length and line quality self-calibration.

Do not connect the power supply to the receiver until after the CAT5 connection. The HD44CC5 must be powered on before the HDRXSG01.

As an alternate process to this procedure, the power may be cycled off for a few seconds and reapplied to accomplish the same full self- calibration process.

If for some reason the system losses power at the receiving end (HDRXSG01), the transmitting end (HD44CC5), or both ends, the full self-calibration process will automatically occur.

08905071B - 7 -