Seagate ST1000DM003, STBD3000100, STBD2000101, ST2000DM001 Drive mounting, Attaching Sata cabling

Page 26

Configuring and Mounting the Drive

www.seagate.com

Figure 1 Attaching SATA cabling

Signal connector

Power connector

Signal cable

Power cable

Each cable is keyed to ensure correct orientation. Barracuda drives support latching SATA connectors.

3.4Drive mounting

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 2, Figure 3, and Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:

•Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.

•Use only 6-32 UNC mounting screws.

•The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.

•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

Figure 2 Mounting dimensions (3-disk: 3TB, 2TB; 2-disk: 2TB, 1.5TB models)

Temperature

Check Point

26	Barracuda SATA Product Manual, Rev. G

Image 26

Contents Barracuda Document Revision History Revision Date Description of ChangeContents Barracuda Sata Product Manual, Rev. G Figures Barracuda Sata Product Manual, Rev. G Seagate Technology Support Services Barracuda Sata Product Manual, Rev. G Introduction About the Sata interfaceIntroduction Drive Specifications Specification summary tablesDrive Specifications Drive Specification ST500DM002 ST320DM000 ST250DM000 Model Formatted Guaranteed Bytes per sector Capacity Sectors Formatted capacityRecording and interface technology LBA modeDefault logical geometry Physical characteristics Seek timeStart/stop times Power specificationsPower consumption DiskDC power requirements 3-disk 3TB and 2TB models Conducted noise Power-management modesPower modes Heads Spindle Buffer Voltage toleranceHumidity Environmental specifications Ambient temperatureTemperature gradient AltitudeNon-operating vibration AcousticsTest for Prominent Discrete Tones PDTs WarrantyAgency certification Safety certification Electromagnetic immunityKorean RRL Electromagnetic compatibilityFCC verification Australian C-Tick N176Corrosive environment Environmental protectionChina Restriction of Hazardous Substances RoHS Directive Sata cables and connectors Handling and static-discharge precautionsConfiguring the drive Drive mounting Attaching Sata cablingMounting dimensions 1-disk 1TB and 750GB models Mounting dimensions 1-disk 500GB, 320GB and 250GB models Sata Interface Segment Pin Function DefinitionE5H Supported ATA commandsCommand name Command code in hex ECH E7HEAH E3HB0H / DAH C6HE6H E2H0C5AH Identify Device commandWord Description Value AsciiXx07H BE09HBit Word FffehMedia serial number is supported 0BH Set Features command0AH 0CH3 S.M.A.R.T. commands Code in features register A.R.T. commandIndex Barracuda Sata Product Manual, Rev. G Barracuda Sata Product Manual, Rev. G Page Page Seagate Technology LLC Americas