Seagate ST96023AS Configuring and mounting the drive, Handling and static-discharge precautions

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Momentus 7200.1 SATA Product Manual, Rev. B

19

Image 25

Contents ST910021AS ST980825AS ST96023AS ST94015AS Momentus 7200.1 SataPage Contents Momentus 7200.1 Sata Product Manual, Rev. B List of Figures Page Introduction About the Serial ATA Sata interface Specification summary table Drive specificationsTrack-to-track seek time msec typical LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Drive specification Physical characteristicsPhysical organization Recording and interface technologyStart/stop times Seek timeTypical seek times Typical seek times msec Read WritePower specifications Deferred spinup Typical current profilesAdditional details Power management modes Power-management modesActive mode Idle modeEnvironmental specifications Operating shock ShockNonoperating shock VibrationElectromagnetic immunity AcousticsDrive level acoustics Radio frequency environmentsMeasurement type Specification Safety certificationReliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification European Union Restriction of Hazardous Substances RoHS Environmental protectionCorrosive environment Momentus 7200.1 Sata Product Manual, Rev. B Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions-top, side and end viewMomentus 7200.1 Sata Product Manual, Rev. B Signal Serial ATA connector pin definitionsSerial ATA Sata interface Segment Pin Function DefinitionP10 Ground 2nd mate P11 Reserved Pin Function DefinitionCommand name Command code in hex ATA-standard commands Supported ATA commandsATA-standard power-management commands Command name Command code in hexMomentus 7200.1 Sata Product Manual, Rev. B Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Internet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index ITE Sata Momentus 7200.1 Sata Product Manual, Rev. B Page Seagate Technology LLC