Seagate ST1000VM002, ST2000VM003 Supported ATA commands, Command name Command code in hex, E5H

Table 6 Serial ATA connector pin definitions (continued)

Notes:

1.All pins are in a single row, with a 1.27mm (0.050”) pitch.

2.The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are:

•the ground pins P4 and P12.

•the pre-charge power pins and the other ground pins.

•the signal pins and the rest of the power pins.

3.There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration.

4.All used voltage pins (Vx) must be terminated.

4.3Supported ATA commands

The following table lists Serial ATA standard commands that the drive supports.

For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial ATA Revision 3.0 (http://www.sata-io.org).

See “S.M.A.R.T. commands” on page 38.for details and subcommands used in the S.M.A.R.T. implementation.

Table 7 Supported ATA commands