Seagate ST3320613AS, ST31000333AS, ST31500341AS, ST3160813AS Start/stop times, Power specifications

Page 18

2.6

Start/stop times

 

 

 

 

 

 

 

 

 

 

 

 

1500 GB

1000 GB

640 GB

320 & 160 GB

 

 

Models

Models

Models

Models

Power-on to Ready (typ / max sec)

12 / 20

9 / 16

 

 

 

 

Power-on to Ready (typ / max sec) (2.0 Amp Code Option)

14 / 20

6 / 9

 

 

 

 

Standby to Ready (typ / max sec)

12 / 20

9 / 16

6 / 9

 

 

 

 

 

Ready to spindle stop (typ / max sec)

 

10 / 20

 

6 / 10

 

 

 

 

 

 

2.7Power specifications

The drive receives DC power (+5V or +12V) through a native SATA power connector. See Figure 2 on page 22.

2.7.1Power consumption

Power requirements for the drives are listed in the table on page 9. Typical power measurements are based on an average of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature.

• Spinup power

Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.

• Seek mode

During seek mode, the read/write actuator arm moves toward a specific position on the disc surface and does not execute a read or write operation. Servo electronics are active. Seek mode power represents the worst-case power consumption, using only random seeks with read or write latency time. This mode is not typical and is provided for worst-case information.

• Read/write power and current

Read/write power is measured with the heads on track, based on a 16-sector write followed by a 32-msec delay, then a 16-sector read followed by a 32-msec delay.

• Operating power and current

Operating power is measured using 40 percent random seeks, 40 percent read/write mode (1 write for each 10 reads) and 20 percent drive idle mode.

• Idle mode power

Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location.

• Standby mode

During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in power-down mode.

12

Barracuda 7200.11 Serial ATA Product Manual, Rev. C

Image 18
Contents Barracuda 7200.11 Serial ATA Revision history Revision Date Sheets affected or commentsContents Barracuda 7200.11 Serial ATA Product Manual, Rev. C List of Figures Page Introduction About the Serial ATA interface Drive specifications Drive specifications summary for 1500 and 1000 Gbyte models Will display the warranty information for your drive Drive specifications summary for 640 Gbyte models Barracuda 7200.11 Serial ATA Product Manual, Rev. C Drive specifications summary for 320 and 160 Gbyte models Barracuda 7200.11 Serial ATA Product Manual, Rev. C Formatted capacity Default logical geometryLBA mode Recording and interface technologyPhysical characteristics Seek timeTypical seek times msec Read Write Power specifications Start/stop timesDC power requirements Idle mode Power-management modesActive mode Sleep modeEnvironmental specifications Vibration Nonoperating shock 1500, 1000 and 640 GB models160 GB models Operating vibrationFluid Dynamic Bearing FDB motor acoustics AcousticsElectromagnetic immunity Test for Prominent Discrete Tones PDTsAgency certification Safety certificationReliability Electromagnetic compatibilityKorean RRL Australian C-Tick N176FCC verification Environmental protection Corrosive environmentChina Restriction of Hazardous Substances RoHS Directive Configuring and mounting the drive Handling and static-discharge precautionsConfiguring the drive Serial ATA cables and connectorsMounting dimensions 1500, 1000 and 640 GB models Drive mountingMounting dimensions 320 and 160 GB models Serial ATA Sata interface Hot-Plug compatibilitySignal Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions Pin Function DefinitionSupported ATA commands Supported ATA commandsCommand name Command code in hex F4H Identify Device command Word Description ValueXx07H Description if bit is set to Bit Word Bit WordWord Set Features command Set Features command values3 S.M.A.R.T. commands M.A.R.T. commandsCode in features register A.R.T. command Presales Support Seagate Technology support servicesInternet Technical SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Index ITE Page Barracuda 7200.11 Serial ATA Product Manual, Rev. C Page Disc Drive, Scotts Valley, California 95066-4544, USA