Seagate ST3250310CS Acoustics emissions, Electromagnetic immunity, Radio frequency environments

Page 19

2.10Acoustics emissions

Drive emission of sound is measured consistent with the ECMA-74 and its referenced standards. Testing is conducted at room temperature (approximately 25 degrees C). Emission levels are reported as the total A-weighted sound power levels for, steady state, idle and active (seek) modes of operations.

Table 3:

Drive A-weighted Sound Power Levels (SWL, BA)

 

 

 

 

 

 

Idle[1]

CE seek profile

 

 

 

 

250 GB model

2.5 bels (typ)

2.6 bels (typ)

2.8 bels (max)

2.8 bels (max)

 

 

[1]During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

Test for Prominent Discrete Tones (PDTs)

Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this pro- cess is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.

* Defined as the median curve given by ISO 389-7 (Tf curve) minus 10dB at all frequencies.

2.11Electromagnetic immunity

When properly installed in a representative host system, the drive operates without errors or degradation in performance when subjected to the radio frequency (RF) environments defined in the following table:

Table 4:

Radio frequency environments

 

 

 

 

 

 

 

Test

 

Description

Performance level

Reference standard

 

 

 

 

 

Electrostatic

 

Contact, HCP, VCP: ± 4 kV; Air: ± 8 kV

B

EN 61000-4-2: 95

discharge

 

 

 

 

Radiated RF

 

80 to 1,000 MHz, 3 V/m,

A

EN 61000-4-3: 96

immunity

 

80% AM with 1 kHz sine

 

ENV 50204: 95

 

 

900 MHz, 3 V/m, 50% pulse modulation @ 200 Hz

 

 

Electrical fast

± 1 kV on AC mains, ± 0.5 kV on external I/O

B

EN 61000-4-4: 95

transient

 

 

 

 

Surge immunity

± 1 kV differential, ± 2 kV common, AC mains

B

EN 61000-4-5: 95

 

 

 

 

Conducted RF

150 kHz to 80 MHz, 3 Vrms, 80% AM with 1 kHz sine

A

EN 61000-4-6: 97

immunity

 

 

 

 

Voltage dips,

 

0% open, 5 seconds

C

EN 61000-4-11: 94

interrupts

 

0% short, 5 seconds

C

 

 

 

40%, 0.10 seconds

C

 

 

 

70%, 0.01 seconds

B

 

DB35.4 Series SATA Product Manual, Rev. B

13

Image 19
Contents ST3250310CS DB35.4 Series SataRevision Date Revision historyContents DB35.4 Series Sata Product Manual, Rev. B List of Figures Page Introduction About the Serial ATA interface Specification summary tables Drive specificationsDrive specification ST3250310CS Drive specifications summary for 250 Gbyte modelDB35.4 Series Sata Product Manual, Rev. B Recording and interface technology Default logical geometryLBA mode Formatted capacityTypical seek times msec Read Write Physical characteristicsSeek time Start/stop timesPower specifications Conducted noise Typical current profilesVoltage tolerance Sleep mode Power-management modesActive mode Idle modeEnvironmental specifications Operating vibration VibrationNonoperating vibration Test for Prominent Discrete Tones PDTs Drive A-weighted Sound Power Levels SWL, BAAcoustics emissions Electromagnetic immunityAnnualized Failure Rate AFR Safety certificationReliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification Corrosive environment Environmental protectionChina Restriction of Hazardous Substances RoHS Directive Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensionsDB35.4 Series Sata Product Manual, Rev. B Hot-Plug compatibility Serial ATA Sata interfacePin Function Definition Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions SignalSupported ATA commands Supported ATA commandsCommand name Command code in hex F4H Word Description Value Identify Device commandXx07H 129 Seagate-reserved Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Technical Support Seagate Technology support servicesInternet Presales SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index ITE Page DB35.4 Series Sata Product Manual, Rev. B Page Seagate Technology LLC