Seagate ST36421A manual Recording and interface technology, Physical characteristics, Seek time

Page 14

6U4 Family Product Manual, Rev. D

1.3 Recording and interface technology

Interface

ATA

 

Recording method

16/17 EPRML

Recording density BPI (bits/inch)

241,000

Track density TPI (tracks/inch)

13,100

Areal density (Mbits/inch2 max)

3,179

Spindle speed (RPM) (± 0.2%)

5,400

Internal data-transfer rate

 

 

(Mbits/sec max)

206

 

I/O data-transfer rate

16.6

(PIO mode 4)

(Mbytes /sec max)

66.6

(Ultra DMA mode 4)

Interleave

1:1

 

Cache buffer (Kbytes)

256

 

1.4 Physical characteristics

Drive Specification

ST38421A, ST36421A,

 

 

ST34311A, ST32112A

 

 

 

 

 

 

Maximum height

(mm)

26.1

 

(inches)

1.028

 

 

 

Maximum width

(mm)

101.8

 

(inches)

4.020

 

 

 

Maximum length

(mm)

147.0

 

(inches)

5.78

 

 

 

Typical weight

(grams)

580

 

(pounds)

1.2

 

 

 

1.5 Seek time

Seek measurements are taken with nominal power at 25°C ambient temperature. All times are measured using drive diagnostics. The spec- ifications in the table below are defined as follows:

Track-to-track seek time is an average of all possible single-track seeks in both directions.

Image 14
Contents Product Manual Page Product Manual Page Contents Configuring and mounting the drive ATA interfaceFigures Seagate Connfidential Review Draft not for DistributionSeagate Confidential Review Draft not for Distribution Introduction Specification summary table Track-to-track seek time Msec typical Vibration, nonoperating Formatted capacity Default logical geometryLBA Mode Physical organizationRecording and interface technology Physical characteristicsDrive Specification ST38421A, ST36421A ST34311A, ST32112A Seek timeSpinup power Power specificationsPower consumption Start/stop timesOperating power and current Seek ModeRead/Write power and current Idle mode powerCurrent amps Time seconds Power Mode Typical Watts Typical Amps RMS 12VTypical current profile Voltage tolerance Power-management modesConducted noise Humidity Environmental tolerances Ambient temperatureTemperature gradient Relative HumidityShock Wet bulb temperatureAltitude Operating shockDrive acoustics Operating vibrationNonoperating vibration Reliability Agency certification Safety certificationElectromagnetic susceptibility Electromagnetic compatibilityFCC verification Australian C-TickU4 Family Product Manual, Rev. D Configuring and mounting the drive Handling and static-discharge precautionsJumper settings Master/slave configuration Master/slave jumper settingsUltra ATA/66 cable Important mounting precautionsCable-select option Drive mountingMounting dimensions-top, side and end view ATA interface signals and connector pins ATA interfaceO pins and supported ATA signals ATA Interface commands Supported ATA commands Command name Command code in hex ATA-standard commandsATA-standard power-management commands Identify Drive commandCommand name ATA-standard security commandsWord Description 27-46 Drive model number 40 Ascii char Multiword DMA active and modes Description if bit is set to Bit Word Set Features command 0CH4 S.M.A.R.T. commands Code in Features Register A.R.T. CommandPage U4 Family Product Manual, Rev. D U4 Family Product Manual, Rev. D
Related manuals
Manual 44 pages 34.49 Kb