Seagate ST32112A, ST38421A, ST36421A, ST34311A manual

Page 4

©1999 Seagate Technology, Inc. All rights reserved

Publication Number: SG35116-001, Rev. D, June 1999

Seagate, Seagate Technology, the Seagate logo and U4 are either trademarks or registered trademarks of Seagate Technology, Inc. Other product names are registered trademarks or trademarks of their owners.

Seagate reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission from Seagate Technology, Inc.

Image 4

Contents Product Manual Page Product Manual Page Contents Configuring and mounting the drive ATA interfaceFigures Seagate Connfidential Review Draft not for DistributionSeagate Confidential Review Draft not for Distribution Introduction Specification summary table Track-to-track seek time Msec typical Vibration, nonoperating Default logical geometry LBA ModeFormatted capacity Physical organizationPhysical characteristics Drive Specification ST38421A, ST36421A ST34311A, ST32112ARecording and interface technology Seek timePower specifications Power consumptionSpinup power Start/stop timesSeek Mode Read/Write power and currentOperating power and current Idle mode powerTypical current profile Power Mode Typical Watts Typical Amps RMS 12VCurrent amps Time seconds Conducted noise Power-management modesVoltage tolerance Environmental tolerances Ambient temperature Temperature gradientHumidity Relative HumidityWet bulb temperature AltitudeShock Operating shockNonoperating vibration Operating vibrationDrive acoustics Agency certification Safety certification Electromagnetic susceptibilityReliability Electromagnetic compatibilityFCC verification Australian C-TickU4 Family Product Manual, Rev. D Configuring and mounting the drive Handling and static-discharge precautionsJumper settings Master/slave configuration Master/slave jumper settingsImportant mounting precautions Cable-select optionUltra ATA/66 cable Drive mountingMounting dimensions-top, side and end view ATA interface signals and connector pins ATA interfaceO pins and supported ATA signals ATA Interface commands Supported ATA commands Command name Command code in hex ATA-standard commandsIdentify Drive command Command nameATA-standard power-management commands ATA-standard security commandsWord Description 27-46 Drive model number 40 Ascii char Multiword DMA active and modes Description if bit is set to Bit Word Set Features command 0CH4 S.M.A.R.T. commands Code in Features Register A.R.T. CommandPage U4 Family Product Manual, Rev. D U4 Family Product Manual, Rev. D

Related manuals

Manual 44 pages 34.49 Kb