Williams Sound WIRSYS 90 ADV Select the Audio Processing Application Preset, Adjusting Tone

Page 8

SoundPlus™ Infrared Listening System

Select the Audio Processing Application Preset

The WIR TX90 offers three preset audio processing options for the most common applications: Music, Voice, and Hearing Assist. Use the “Music” setting when maximum dynamic range and audio quality are preferred. Use the “Voice” setting for simultaneous interpretation, audio description, or other applications with users that have primarily normal hearing. Use the “Assist” setting for hearing assistance applications to meet the reduced dynamic range needs of hearing impaired listeners. You may select the same audio pre-set for both Channel A and Channel B, or you may select them independently.

To select the audio processing preset, you must first activate the channel you want to adjust. Press the “channel” button to activate the channel(s) you want to choose an audio processing preset for, then press the “Presets” button to choose the preset. The Music, Voice, or Assist indicator will light to show your selection. After 10 seconds, the setting will be stored.

Adjusting Audio Input Level

The TX90 is designed to accept a line-level audio input signal. The “Level” indicator light for each channel is used to help adjust the audio input level. When the indicator does not light, the input signal level is too low. When the indicator is flashing, the signal level is optimal. When the indicator is steadily lit, but does not flash, the input level is too high and can cause distortion. You can adjust the input level of both channels simultaneously, or independently.

Make sure the input audio signal is connected to the WIR TX90. To adjust the audio input level, first activate the channel(s) you want to adjust by pressing the “CHANNEL” button, then press the “VOLUME” button. The Volume indicator will light. Now, turn the “ADJUST” knob clockwise to increase the input signal or counter-clockwise to decrease the input signal until the channel “Level” indicator is flashing. After 10 seconds, the setting will be stored.

IMPORTANT 

Audio level NORMAL (optimal): the audio indicator level will flash at a 1 second rate.

Audio level too HIGH: the audio indicator level will stay on or flash erratically.

Audio level too LOW: the audio indicator level will be off.

Adjusting Tone

The WIR TX90 has a tone adjustment to suit user preference and to compensate for the different frequency responses of various infrared receiver models. First, make sure the audio source is active. Use a receiver from the system to listen to the signal as you adjust the tone control.

To adjust the tone, first activate the channel(s) you want to adjust by pressing the “CHANNEL” button, then press the “TONE” button. The tone indicator will light. Now turn the “ADJUST” knob clockwise to emphasize high frequencies (best for hearing assistance use). When you have reached the maximum adjustment, there will be no further change in tone. Turn the “ADJUST” knob counter-clockwise to decrease the high frequency emphasis. When you have reached the minimum adjustment, there will be no further change in tone. After 10 seconds, the setting will be stored.

8

MAN 119H

Image 8
Contents SoundPlus SoundPlus Infrared Listening System System Overview Mounting RX22-4 Receivers BracketDetermine Coverage Area RX18 ReceiverDimension Foot Pattern Connect Power Power Connection for U.S. ApplicationSelecting a Channel Connect Audio SourceSelecting a Carrier Frequency Adjusting Tone Select the Audio Processing Application PresetAdjusting Audio Input Level Connecting a WIR TX9 Emitter to a WIR TX90 Transmitter Receiver Safety Information Recycling InstructionsOptional Infrared Receivers LeftOptional Chargers CHG 518 BackTrouble Shooting WIR TX90 Power On indicator is not litLimited Warranty SoundPlus Infrared Listening System Specifications Infrared Transmitter, Model WIR TX9055344