Introduction
Setting the Lens and
Switches
Set the video setting switches on the camera unit before mounting it.
To set the switches, use a
ARESET/[SPOT]
B
R
B
LLPHASE
1 O
2 N 2
C | 4 | 4 | ||
|
| 3 |
|
|
|
| 5 |
| WHT. |
|
|
| ||
|
| 6 |
| |
|
| 7 |
| BAL. |
|
| 8 |
|
|
D
L H
IRIS
ELEVEL
FOCUS ADJUST
F
G
Function selection switch setting table (Items in bold are factory position)
|
| OFF | ON |
|
|
|
|
1 | AGC | OFF | ON |
2 | SELECT | PHASE | WHT.BAL. |
3 | SYNC | LL | INT |
4 | WHT.BAL. | ATW | MANU |
5 | BLC | OFF | ON |
6 | DAY/NIGHT | OFF | ON |
7 | RESERVED | SET TO OFF | |
8 | RESET/SPOT | RESET | SPOT |
A [RESET/SPOT] RESET/SPOT button
When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value.
●When the 2 [SELECT] switch is set to WHT.BAL., the white balance is reset to the default value.
When the switch is set to PHASE, the phase is reset to the default value.
●When setting to SPOT:
When this button is pressed, white spots are corrected.
For instructions on correcting white spots, see
B[R/B,
This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock.
The function of this button is selected using the 2 [SELECT] switch.
●When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint.
Press the B button to increase the blue tint and decrease the red tint.
●When adjusting the phase:
Press the + or - button to adjust the phase.
CFunction selection switches
1.[AGC]
2.[SELECT] WHT.BAL./PHASE setting switch.
WHT.BAL.:
The B [R/B,
PHASE:
The B [R/B,
(Default setting: WHT.BAL.)
3.[SYNC] Synchronization system selection switch.
This switch sets the synchronizing system for the camera.
INT:
This is set for internal synchronization
LL (Line Lock):
The camera’s vertical synchronization is locked to the AC 24 V 60 Hz power line frequency. When switching between multiple cameras using a switcher, selecting this mode and adjusting the vertical phase can reduce the monitor sync disturbances occur that when the camera image is switched.
(Default setting: INT)
10