Seagate ST34555N/W manual General information, Drive models

Page 20

18	Hawk 4XL Installation Guide, Rev. A

Initial setup information

The general information beginning on this page applies to all of the Hawk 4XL drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models	Page
ST34555N	36
ST34555W	40

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables

•Formatting the drive

Image 20

Contents

Hawk 4XL Disc Drive ST34555N/W Installation Guide Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Hawk 4XL Installation Guide, Rev. a Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Electromagnetic compliance for the European Union Australian C-TickSeagate technical support services Online servicesSeagate CompuServe forum FAX services SeaFAXDirect-support services Seagate technical supportCustomer service centers Manufacturer’s representatives General description Drive characteristics RPMSingle-ended DC power requirements AmpsST34555N/W Dimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Fifty pin I/O connection to drive N model Multiple drive connection to host adapter Multiple-drive connection to host adapter Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelHawk 4XL Installation Guide, Rev. a DC power connector Abbildung 5. Gleichstromanschluß Hinweis Page Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsSetting the Scsi ID on model W drives Host Alternate Enable Scsi terminator Disable Scsi terminator Model only Terminator power Other option jumpers are available as illustrated below