Tyco Electronics ET1528L manual EMC Guidance, Cispr

EMC Guidance

Guidance and manufacturer’s declaration – electromagnetic emissions

The 1528L is intended for use in the electromagnetic environment specified below. The customer or the user of the 1528L should assure that it is used in such an environment.

Emissions test	Compliance	Electromagnetic environment – guidance
RF emissions	Group 1	The 1528L uses RF energy only for its internal function. Therefore, its RF emissions
CISPR 11		are very low and are not likely to cause any interference in nearby electronic
		equipment.
RF emissions	Class B
Harmonic	Not applicable
emissions
IEC61000-3-2
Voltage	Complies
fluctuations/
flicker emissions
IEC61000-3-3

Guidance and manufacturer’s declaration – electromagnetic immunity

The 1528L is intended for use in the electromagnetic environment specified below. The customer or the user of the 1528L should assure that it is used in such an environment.

Immunity test	IEC60601	Compliance level	Electromagnetic environment –
	test level		guidance
Electrostatic discharge	±6 kV Contact	±6 kV Contact	Floors should be wood, concrete or
(ESD)	±8 kV air	±8 kV air	ceramic tile. If floors are covered with
IEC61000-4-2			synthetic material the relative humidity
			should be at least 30 %
Electrical fast	±2 kV for power supply	±2 kV for power supply	Main power quality should be that of a
transient/burst	lines	lines	typical commercial or hospital
IEC61000-4-4	±1 kV for input/output	±1 kV for input/output	environment.
	lines	lines
Surge	±1 kV differential mode	±1 kV differential mode	Main power quality should be that of a
IEC6100-4-5	±2 kV common mode	±2 kV common mode	typical commercial or hospital
			environment.
Voltage dips, short	<5 % UT	<5 % UT	Main power quality should be that of a
interruptions and voltage	(>95 % dip in UT)	(>95 % dip in UT)	typical commercial or hospital
variations on the power	for 0,5 cycle	for 0,5 cycle	environment. If the user of the 1528L
supply input lines	40 % UT	40 % UT	requires continued operation during power
IEC61000-4-11			mains interruptions, it is recommended
	(60 % dip in UT)	(60 % dip in UT)	that the 1528L be powered from an
	for 5 cycles	for 5 cycles	uninterruptible power supply or a battery.
	70 % UT	70 % UT
	(30 % dip in UT)	(30 % dip in UT)
	for 25 cycles	for 25 cycles
	<5 % UT	<5 % UT
	(>95 % dip in UT)	(>95 % dip in UT)
	for 5 sec	for 5 sec
Power frequency	3 A/m	3 A/m, 30 A/m	Power frequency magnetic fields should
(50/60 Hz)			be at levels characteristic of a typical
Magnetic field			location in a typical commercial or
IEC61000-4-8			hospital environment.

NOTE UT is the ac. mains voltage prior to application of the test level.

v