Tyco Electronics ET 1900L manual Attaching the Stand to a Mounting Surface

Page 14

Monitor Mounting and Orientation (continued)

Attaching the Stand to a Mounting Surface

Option 1 — Mounting from the top.

Slide out stand base cover. Use 4 screws to attach stand to surface.

Option 2 — Mounting from the bottom.

Attach to the surface using the holes shown above.

Elo TouchSystems 1900L User Guide 14

Image 14

Contents 1900L 19-inch LCD Touchmonitor User Guide Revision a E483389 Elo TouchSystemsCopyright 2008 Tyco Electronics. All Rights Reserved Table of Contents Introduction About the ProductPrecautions Installation and Setup Unpacking Your Touchmonitor Check that the following items are presentTo connect the touchmonitor to the computer Connecting the Cables to the Touchmonitor and ComputerConnector Panel Underneath the Monitor Installing the Touch Driver Click on Install Driver for This ComputerMonitor Overview and Dimensions Monitor Mounting and Orientation Option 1- Mount on Flat Surface with StandOption 2 Mount using Vesa Attaching the Stand to a Mounting Surface About Touchmonitor Adjustments OperationOSD Menu Functions On-Screen Display OSD Control PanelOSD Control Buttons Power Lock/Unlock OSD Lock/UnlockPhase Auto AdjustImage Setting VGA only Position OSD TimeoutMiscellaneous Aspect Ratio Recall DefaultsRecall Color Recall SharpnessPreset Display Modes Speakers and Audio Features Troubleshooting Solutions to Common ProblemsTechnical Support Touchmonitor Safety Care and Handling of Your Touchmonitor Waste Electrical and Electronic Equipment Weee DirectiveTechnical Specifications 1900L Specifications Preset Display ModesDisplay Color Regulatory Information Elo TouchSystems 1900L User Guide FCC Warranty Elo TouchSystems 1900L User Guide Getting in Touch with Elo