B)Notice to Users in Canada: This equipment complies with the Class B limits for radio noise emissions from digital apparatus as established by the Radio Interference Regulations of Industry Canada.
C)Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for emissions or immunity as required by the following standards: This Information Technology Equipment (ITE) is required to have a CE Mark on the manufacturer’s label which means that the equipment has been tested to the following Directives and Standards:
This equipment has been tested to the requirements for the CE Mark as required by EMC Directive 89/336/EEC indicated in European Standard EN 55022 Class B and the Low Voltage Directive 73/23/EEC as indicated in European Standard EN 60950.
D)General Information to all Users: This equipment generates, uses and can radiate radio frequency energy. If not installed and used ac- cording to this manual, the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to site- specific factors.
1)In order to meet emission and immunity requirements, the user must observe the following:
a)Use only the provided I/O cables to connect this digital device with any computer.
b)To ensure compliance, use only the provided manufacturer’s approved power cord.
c)The user is cautioned that changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
2)If this equipment appears to cause interference with radio or television reception, or any other device:
a)Verify as an emission source by turning the equipment off and on.
b)If you determine that this equipment is causing the