Tyco Electronics 15A2 manual Using the I/O panel

Page 30

Using the I/O panel

The touchcomputer provides the following I/O interfaces for connecting a wide variety of compliant devices.

USB and Powered USB

There are four USB 2.0 type A ports, including one 12V powered USB 2.0 port.

Cash Drawer

When the registered jack (RJ) is set as a cash drawer port via the touchcomputer BIOS control, it provides a 12V cash drawer interface. For additional information, see the Cash Drawer Port Signal Definition and Control section on page 44.

Modem

When the registered jack (RJ) is set as a modem port via the touchcomputer BIOS control, it provides an RJ11 interface for when the optional modem daughter card is installed in the touchcomputer.

Ethernet

There is one RJ45 Ethernet port providing LAN capabilities

Serial

There are two serial ports with an 8 position registered jack connector interface. COM1 is set to RS232 mode. COM2 is selectable in the BIOS to RS232, RS422 or RS485 modes. Use the supplied DB9 adapter cable to change the interface to DB9.

Microphone Input

There is one 3.5mm microphone input jack for connecting an external microphone

Audio Output

There is one 3.5mm stereo audio output jack for connecting headphones or external powered speakers.

Elo TouchSystems 15A2 User Guide 30

Image 30

Contents Touchcomputer User Guide Elo TouchSystems Touchcomputer User Guide Copyright c 2008 Tyco Electronics. All Rights Reserved DisclaimerTable of Contents Regulatory Information Warranty Setup Unpacking Your TouchcomputerProduct Overview Front View Rear ViewSide View Base Bottom View Display Orientation Display Orientation with Peripherals Initial Turn-On Language SelectionPage Time-zone selection Testing the Touchscreen Test DevicesCalibration Testing the Magnetic Stripe Reader MSR optional Testing in USB MSR Keyboard KB Emulation ModeTesting in USB MSR Human Interface Device HID Mode Converting MSR from Keyboard Emulation to HID and vice versa Testing the Customer Display optional Testing the Finger Print Reader optional Testing the Barcode Scanner optional Page Enabling 2-D Scanning Testing the Speaker Bar optional Testing the Wireless Card optional Testing the TV tuner optionalTesting the Cash Drawer Port Testing the Modem CardoptionalElo TouchSystems 15A2 User Guide Operation OSD Control OSD MenuTo lock the OSD OSD LockoutShortcut keys To unlock the OSDPower Lockout Power ControlPower Button To lock the PowerUsing the I/O panel PS/2 Universal TV Tuner optionalKensingtonTM Lock Snap off stand cover Securing the Touchcomputer BaseMounting Option Mount as shownBottom View Display Angle Upgrades Adding PeripheralsMaintenance Care and Handling of Your Touchcomputer Waste Electrical and Electronic Equipment Weee DirectiveTo Install the Hard Disk Drive Servicing the Hard Disk Drive and Compact Flash CardRecovering the Operating System To Install the Compact Flash CardTechnical Specifications Touchcomputer Specifications RAMPage COM1, COM2 ConnectorRS232 Mode RS422 Mode Pin Definitionfor COM2 onlyRS485 Mode Pin Definitionfor COM2 only Power Input Pin Definition Cash Drawer Port Signal Definition and Control ControlDisplay Specifications ESY15A2Power Supply Specifications Touchscreen Specifications Customer Display Peripheral SpecificationsMagnetic Stripe Reader MSR USB VersionFingerprint Reader One-Dimensional scanner specifications Barcode ScannerSpeaker Bar Wireless Card TV Tuner CardModem Card Environmental Specifications Temperature RangesTechnical Support Using the TouchcomputerUsing the Web Using the Phone Technical AssistanceElectrical Safety Information Regulatory InformationII. Emissions and Immunity Information Page III. Safety Label Warranty Page Check out Elo’s Website