Tyan Computer B5161 manual Safety Information

Page 6

SAFETY INFORMATION

Before installing and using the Transport GT20, take note of the fol- lowing precautions:

Read all instructions carefully.

Do not place the unit on an unstable surface, cart, or stand.

Do not block the slots and opening on the unit, which are pro- vided for ventilation.

Only use the power source indicated on the marking label. If you are not sure, contact the Power Company.

The unit uses a three-wire ground cable, which is equipped with a third pin to ground the unit and prevent electric shock. Do not defeat the purpose of this pin. If your outlet does not support this kind of plug, contact your electrician to replace your obsolete outlet.

Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic.

Follow all warnings and cautions in this manual and on the unit case.

Do not push objects in the ventilation slots as they may touch high voltage components and result in shock and damage to the components.

When replacing parts, ensure that you use parts specified by the manufacturer.

When service or repairs have been done, perform routine safety checks to verify that the system is operating correctly.

Avoid using the system near water, in direct sunlight, or near a heating device.

Cover the unit when not in use.

iv

Image 6
Contents Transport GT20 B5161 Service Engineer’s Manual Page Preface Federal Communications Commission FCC About this Manual Safety Information Table of Contents Technical Support Overview About the Transport GT20 B5161Features EnclosureRegulatory Unpacking Opening the BoxBox Contents Component DescriptionAccessories FDD Kit About the Product Front ViewRear View LED Definition Front PanelRJ45 NIC2 Mode Amber Gigabit mode Right Side Green 100M mode Internal View 1110 Motherboard Block Diagram CPU Motherboard LayoutJumpers & Connectors Jumper Function ConnectorBefore You Begin Work AreaTools Precautions Installing the Server in a Rack Rack MountingRack mounting kit Installing the Inner Rails to Chassis Installing Outer Rails to the RackLocate the front and rear brackets Remember to add washer Front Side Rear Side Rackmounting the Server Setting Up Installing Motherboard Components Removing the Chassis CoverInstalling the CPU, Heatsink and Air Duct Setting Up Setting Up Installing the Memory Installing the PCI Card Installing the Hard Drive Setting Up Installing the Slim FDD Option Connect the other side to the connector on motherboard Replacing Pre-Installed Components IntroductionPrecautions Disassembly Flowchart Following flowchart outlines the disassembly procedureRemoving the Cover Disconnecting All Motherboard Cables Main Power EPS 12V PowerReplacing Motherboard Components Removing the Motherboard Replacing the LED Control Board Replacing Pre-Installed Components Replacing the M1012 Adapter Board 2x power cables on Sata backplane 1x power cable on M1012 1 M1012 Adapter Board Features J3 LAN/ID LED2 M1012 Adapter Board Connector Pin Definition FAN Signal Related Connector Pin Definition GND FAN1TACH FAN2TACH FAN3TACH KEY PIN FAN312VPWM FAN3TACH GND FAN4TACH FAN412VPWM FAN912VPWM FAN9TACH GND FAN10TACH System Fan Monitoring Signal System Fan LayoutReplacing the Sata Backplane ATA Backplane M1204 Features Replacing Pre-Installed Components Replacing the Cooling Fan Replacing the Power Supply Appendix I Bios Differences Difference 1 Main Menu/Legacy Diskette aDisabled B5161Difference 2 Advanced/Hardware Monitor S5161 B6161B5161 Appendix II Cable Connection Tables Power Supply Cable CD-ROM Related Cable Appendix III Installing Smdc Cards Installing M3289 into HDD Tray Page Installing M3290/M3291 into HDD tray Installing M3290/M3291 into GT24 Chassis Page Technical Support Help ResourcesReturning Merchandise for Service