Tyan Computer B5161 manual About this Manual

Page 5

About this Manual

This manual provides you with instructions on installing your Transport GT20. This manual is intended for experienced users and integrators with hardware knowledge of personal computers.

This manual consists of the following parts

Chapter 1: Provides an Introduction to the Transport GT20 B5161 barebone, packing list, describes the external components, gives a table of key compo- nents, and provides block diagrams of the system.

Chapter 2: Covers procedures on installing the CPU, mem- ory module, PCI card, and hard drive.

Chapter 3: Covers removal and replacement procedures for pre-installed components

Appendix: Describes the differences between mainboard BIOS and system BIOS. The cable connection tables are also provided for reference of system setup. For SMDC setting up, please refer to Appendix III.

For information on the mainboard, please refer to the attached main- board user’s manual. You can find the detailed description about jumper and BIOS settings from the motherboard manual.

iii

Image 5
Contents Transport GT20 B5161 Service Engineer’s Manual Page Preface Federal Communications Commission FCC About this Manual Safety Information Table of Contents Technical Support About the Transport GT20 B5161 OverviewEnclosure FeaturesRegulatory Opening the Box UnpackingComponent Description Box ContentsAccessories FDD Kit Rear View About the ProductFront View Front Panel LED DefinitionRJ45 NIC2 Mode Amber Gigabit mode Right Side Green 100M mode Internal View 1110 Motherboard Block Diagram Motherboard Layout CPUJumper Function Connector Jumpers & ConnectorsTools Before You BeginWork Area Precautions Rack mounting kit Installing the Server in a RackRack Mounting Installing Outer Rails to the Rack Installing the Inner Rails to ChassisLocate the front and rear brackets Remember to add washer Front Side Rear Side Rackmounting the Server Setting Up Removing the Chassis Cover Installing Motherboard ComponentsInstalling the CPU, Heatsink and Air Duct Setting Up Setting Up Installing the Memory Installing the PCI Card Installing the Hard Drive Setting Up Installing the Slim FDD Option Connect the other side to the connector on motherboard Introduction Replacing Pre-Installed ComponentsPrecautions Following flowchart outlines the disassembly procedure Disassembly FlowchartRemoving the Cover Replacing Motherboard Components Disconnecting All Motherboard CablesMain Power EPS 12V Power Removing the Motherboard Replacing the LED Control Board Replacing Pre-Installed Components Replacing the M1012 Adapter Board 2x power cables on Sata backplane 1x power cable on M1012 J3 LAN/ID LED 1 M1012 Adapter Board Features2 M1012 Adapter Board Connector Pin Definition FAN Signal Related Connector Pin Definition GND FAN1TACH FAN2TACH FAN3TACH KEY PIN FAN312VPWM FAN3TACH GND FAN4TACH FAN412VPWM FAN912VPWM FAN9TACH GND FAN10TACH System Fan Layout System Fan Monitoring SignalReplacing the Sata Backplane ATA Backplane M1204 Features Replacing Pre-Installed Components Replacing the Cooling Fan Replacing the Power Supply Difference 1 Main Menu/Legacy Diskette a Appendix I Bios DifferencesB5161 DisabledB6161 Difference 2 Advanced/Hardware Monitor S5161B5161 Appendix II Cable Connection Tables Power Supply Cable CD-ROM Related Cable Appendix III Installing Smdc Cards Installing M3289 into HDD Tray Page Installing M3290/M3291 into HDD tray Installing M3290/M3291 into GT24 Chassis Page Help Resources Technical SupportReturning Merchandise for Service