Tyco TX 75149 manual Click to Calculate Stability

Page 9

model of the capacitor bank. The load is modeled by the resistance RL.

The second configuration is similar to the first one except that the voltage sense location is moved from the output pins of the module to the load. In this case, the voltage sensed and regulated is not the module output voltage but the voltage across the load, a situation commonly referred to as "remote sensing".

The remaining three configurations (3, 4 and 5) allow the inclusion of more detailed models of the capacitor banks and parasitic elements between the module and the load. In some applications, the power module is mounted on a separate printed circuit board and supplies a number of loads on different PCBs. In this case, it is common to have one capacitor bank on the power board and another one on the load board.

The first capacitor bank, which is a parallel combination of three capacitors, is usually located as close as possible to the module output pins. It conveniently allows for modeling different types of capacitors such as aluminum and tantalum electrolytics and ceramics. When the size and type of capacitors used in a bank are different, their individual frequency responses vary greatly from one another and hence they cannot be modeled as a lumped capacitor as shown in the first two configurations. Note that if you only have one or two types of capacitors, you can still use the model by setting the values corresponding to the other capacitor to zero.

The second capacitor bank is typically placed as close as possible across the load terminals to improve dynamic response during load transients by minimizing the voltage overshoot and undershoot. The capability of modeling two capacitors with their ESR and ESL are provided to model different types and sizes of capacitors.

The three configurations also allow for modeling various sense points for the feedback voltage. Feedback voltage can be sensed across the load (case 3), across the capacitor bank (case 2), or across the module output.

Click on the configuration picture suitable for your application. In this example, we will choose Configuration 4. Clicking on the picture will bring that configuration's page as shown in Figure 4.

The top left section shows the configuration circuit with the feedback voltage sense path depicted in red. Underneath the configuration circuit diagram, circuit parameters are listed with default values that can be edited in blue. The JFW050A module is a 5V, 10A output module and hence in this example, the load resistance is set at 0.5 ohms, indicating a 10A load. You should set the load resistance value corresponding to the actual load in your application. The resistors Ra1, through Ra3, and Rb1 through Rb3 are the ESRs of the capacitors and the inductances La1 through Lb3 are the ESLs.

Enter all circuit parameters of your application. When you finish editing the

parameter values, click on the

 

button.

Click to Calculate Stability

 

 

 

9

Image 9
Contents StabilityAnalysis Tool Users Guide Copyright Page System Requirements IntroductionUSA SAT Introduction and Module Selection Using SATClick on the button Circuit configuration Configuration MenuClick to Calculate Stability Stability Analysis Tool Voltage loop response Bode plot when Cb2=6800 ∝F Paralleled Modules References Limitations of SAT Troubleshooting