USRobotics x2/56K Modem, Connects itself, Correctly to, Remote modem, but, Connection is, Be made

The modem	Someone probably hung up from another
connects itself	extension.
correctly to the	The modem detected a call waiting signal
remote modem, but
	on the line. Contact the local tele-
the connection is
	communications agency to find out how
interrupted during
	to turn this signal off when you use the
communications
	modem.
with the message:
NO CARRIER.	Try calling another modem to check if
	the problem is general or unique to one
	specific modem.
	The telephone line is of low quality; try
	communicating at a lower speed.
Connection problem	Some older modem models will not
with a 2400 bps	connect when the error correction protocol
modem.	is on. Turn this protocol off with the
	following command:
	0,66,1*￿&200$1'
High speed data	Check if there are any time-share
transmission failed.	applications or programs working in
	parallel to the communications application.
	The quality of the telephone line is too
	low to withstand high-speed data transfer;
	decrease the modem's transmission
	speed.
International	Because of the length of the number
connections cannot	dialed and the differences in telephone
be made.	networks, it may be the case that some
	digits do not get interpreted during the
	dialing process. Insert commas between
	parts of the dialing number in order to
	create pauses.
	For example, if you are calling 123456789,
	insert commas and dial 1,23,456789
	instead.
Calls to foreign	Increase the amount of time to wait for
countries terminate	a carrier signal. In terminal mode, type
with a ‘NO CARRIER’	ATS7=60 and press the Enter key. The
message.	range of acceptable values is country-
	dependent.

24 Sportster Winmodem 33600 & x2/56K - User's manual