Link Mode (Switch 2)
Switch Position | Mode |
|
|
Up (default) | Standard Mode |
|
|
Down | Smart Link |
|
|
Standard Mode: In this mode (if Fiber Negotiation is set to OFF), the links on the fiber and copper sides can be brought up and down independently of each other. A loss of link on either the fiber link or copper link can take place without affecting the other connection.
However, if the Fiber Negotiation (switch 1) is set to Auto, then a loss of link on the copper side will result in a loss of link on the fiber side.
Smart Link
If the installation has a Media Converter on both ends of the fiber link and both are setup for Smart Link
Fiber Fault Alert (Switch 3)
Switch Position | Mode |
|
|
Up (default) | Enabled |
|
|
Down | Disabled |
|
|
Disabled: The Media Converter Module will not monitor for fiber fault.
Enabled: If the Media Converter Module detects a loss of fiber signal on the fiber receiver, it will immediately disable its fiber transmitter signal. This notifies the fiber link partner that an error condition exists on the fiber connection.
If the remote Media Converter is set up for Fiber Fault Alert (FFA) Enabled and the local Media Converter is set up with Smart Link