Perle Systems GNS-30CR manual Startup

Page 17

8. Startup

Before startup, the components required for your application must be connected. The SIM card must be inserted into SIM card holder.

The Modem is ready for operation when supply voltage is applied and the ignition line is activated. If the recommended plug-in power supply unit is used, the ignition line is already connected to the supply voltage line, and the Modem is thus immediately switched to the active state. It starts the network search and registers with network operator.

Image 17

Contents GNS-30CR NOVACOM wirelessUser Guide Note The warranty does not apply in the event of improper use 1. Safety information2. Contents 3.1 Front View 3. Overview3.2 Rear View 4.Product description Extended AT commands for industrial applications Wide input voltage range Highly compact, light and powerfulSupport band GNS-30CR EGSM900/DCS1800/PCS1900 Data, voice, SMS and faxTelematics Telemetry Remote monitoring Remote control Security systems Traffic system Fleet management Teleservice4.2 Applications Remote meter reading Mobile office Vending/POSClass11W for DCS 1800/PCS Control via AT commands 5. FeaturesInput voltage range DC+6….. +30V Dimensions 122 × 68 × 21.6mm Weight approx.165g SIM card 3V or Data interface 9pinRS2325.3 Data 5.2 SMSPoint-to-point MT and MO SMS cell broadcast Text and PDU mode CSD up to 14.4kbps USSD Non-transparent modeAntenna connector SMA female RS232 interface Connector for plug-in power supply unit5.4 Fax 5.5 External interfaces6.1 Package contents 6. Installation6.2 Safety and installation information 7. Interface descriptionpower interface internal + / external -supply adaptor 7.1 Plug-in power supply units7.2 SIM card holder A quad band antenna GSM850/EGSM900/DCS1800/PCS1900 can be 7.3 Antenna connector SMA femalefemale coaxial jack Pin assignments7.4 RS232 interface converter which baud rate can support at least 230400bps Use and operatione.g. host computer is connected via the RS232 cable 8. Startup State in GSM network Operating states/LEDThe LED display the following states of the Modem 9. AT command control