'PROGRAM CONTROLLER' MODE
Display Time
On entering Program Controller mode, the very first step lets you program is the display time. This determines the length of time (in seconds) that any VALUE is displayed before message, such as ‘PROCESS’ is flashed.
The unit will first show 'dSPLy t' (for Display Time), and then the
current setting in seconds. Use ‘^DIGv’ and ‘<DIG>’ key to set the desired display time. Push ‘SETUP’ key following the selection.
Display Option:
This is indicated by the display briefly reading 'dSP OPt' (for display option) and then the currently selected Option. Use ‘^DIGv’ key to step thru various options. Once the desired option has been selected, push ‘SETUP’ key to enter it and go on to set Display Time.
Display Mode | Display shows | Description |
PROCESS | PrOCESS | Displays process value. |
SETPOINT DEVIATION | SP. DEVN | Displays setpoint deviaition. |
INSTANTANEOUS RATE | In. rAtE | Displays Instantaneous rate value. |
PROCESS HIGH | Pr. HIGH | Displays process’ highest reading |
PROCESS LOW | Pr. LO | Displays process’ lowest reading |
ELAPSED TIME | ELPSd. T | Displays elapsed time. |
TIMER 1 COUNT DOWN | tr1. Cnt | Display Timer 1 count down value |
TIMER 2 COUNT DOWN | tr1. Cnt | Display Timer 2 count down value |
SCAN | SCAn | Scans through all the above parameters |
Rate Time-Base:
This step is for programming
Page 10