1
1.1 UNPACKING
Remove the Packing List and verify that all equipment has been received. If there are any questions about the shipment, use the phone number for the Customer Service Department nearest you.
Upon receipt of shipment, inspect the container and equipment for any signs of damage. Take particular note of any evidence of rough handling in transit. Immediately report any damage to the shipping agent.
The carrier will not honor any claims unless all shipping material is saved for their
Note ☞ examination. After examining and removing contents, save packing material and carton in the event reshipment is necessary.
1.2 SAFETY CONSIDERATIONS
Refer to your main owners guide manual for complete safety considerations.
This option card is intended for use in a DPF700 panel mount device that is protected in accordance with Class I of EN 61010 (115/230 AC power connections). Installation of this instrument should be done by Qualified personnel.
| • | Do not exceed voltage rating on the label located on the top of the instrument housing. | |
Note ☞ | |||
• | Always disconnect power before changing signal and power connections. | ||
|
•Do not use this instrument on a work bench without its case for safety reasons.
•Do not operate this instrument in flammable or explosive atmospheres.
•Do not expose this instrument to rain or moisture.
•Unit mounting should allow for adequate ventilation to ensure instrument does not exceed operating temperature rating.
•Use electrical wires with adequate size to handle mechanical strain and power requirements. Install without exposing bare wire outside the connector to minimize electrical shock hazards.
1