Preparation before connecting your switch
Before you install your switch, make sure you will be operating the unit within the specified voltage and temperature limits. To install your switch on a flat surface, simply adhere the included rubber feet within the outlines on the bottom surface of the unit. Ensure the switch is positioned with at least 50mm of space on all sides for adequate ventilation.
To install the switch on a wall, measure the distance between the mounting holes on the back of the switch and mark the wall to match the measured distance. At the marked location, screw into the wall two suitably sized screws.
Choose a location that is near the devices to be connected, is close to a suitable electrical outlet, and provides at least 50mm of space all around the switch for ventilation.
Rev.1 - YML671 | www.netcomm.com.au |
NP3005 - 5 Port Gigabit Switch | Page 13 |