NetComm NS370W manual Appendix I Registration and Warranty Information, Contact Information

Page 74

Appendix I: Registration and Warranty Information

All NetComm Limited (“NetComm”) products have a standard 12 month warranty from date of purchase against defects in manufacturing and that the products will operate in accordance with the specifications outlined in the User Guide. However some products have an extended warranty option (please refer to your packaging). To be eligible for the extended warranty you must supply the requested warranty information to NetComm within 30 days of the original purchase by registering on-line via the NetComm web site at:

www.netcomm.com.au

Contact Information

If you have any technical difficulties with your product, please do not hesitate to contact NetComm’s Customer Support Department.

Email:support@netcomm.com.au

Fax:

(+612) 9424-2010

Web:www.netcomm.com.au

Copyright Information

This manual is copyright. Apart from any fair dealing for the purposes of private study, research, criticism or review, as permitted under the Copyright Act, no part may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical, recording or otherwise, without the prior written permission of NetComm Limited. NetComm Limited accepts no liability or responsibility, for consequences arising from the use of this product. Please note that the images used in this document may vary slightly from those of the actual product. Specifications are accurate at the time of the preparation of this document but are subject to change without notice.

NetComm Limited reserves the right to change the specifications and operating details of this product without notice. NetComm is a registered trademark of NetComm Limited. All other trademarks are acknowledged the property of their respective owners.

Customer Information

ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:

(1)This unit shall be connected to the Telecommunication Network through a line cord which meets the require- ments of the ACA TS008 Standard.

(2)This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACA. These standards are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions detailed within this manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur with the installation of this product in your home or office. If this equipment does cause some degree of interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, we encourage the user to try to correct the interference by one or more of the following measures:

•Change the direction or relocate the receiving antenna.

•Increase the separation between this equipment and the receiver.

•Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is connected.

•Consult an experienced radio/TV technician for help.

(3)The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with any other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure to do so may cause damage to this product, fire or result in personal injury.

74

NS370 / NS370W User Guide

 

YML814 Rev1

Page 73 Page 75
Image 74
Page 73 Page 75
Contents Page Contents NS370 / NS370W User Guide YML814 Rev1 Introduction About This GuideFeatures and Benefits Package Contents For Networking For Accessing the CameraSystem Requirements Front Panel Power LEDPhysical Description Link LEDRear Panel Top/Bottom PanelAttaching the Power Supply Hardware InstallationConnecting the Ethernet cable Label Power on the Internet Camera is illuminatedDefined That you set the Admin ID and Admin Password when you useSecurity Home Applications Using the Internet CameraUsage Examples Soho Applications Order to access the camera Web Configuration UtilityAccessing the Camera with the Web Configuration Utility For example, you can change the IP address of your PC toMenu bar will make you return to the Welcome window System AdministrationSystem Administration Management Device Status SystemVideo Ethernet StatusNetwork Wireless NS370W onlyWireless Status Network StatusUser Active UsersSystem Administration Configuration System SettingDummy NormalOFF Video Setting VideoWireless NS370W only Wireless InterfaceEncryption Advanced Setting Network TCP/IPNS370 / NS370W User Guide Define Users User Access ControlUser DateTime Date & TimeUpload FTP ServerTime Schedule Manual OperationMail Mail AccountMail Test System Administration ToolsFTP Test Test FTP AccountFirmware Upgrade ResetFactory Reset BackupBackup Device Configuration to File Restore Device Configuration from FileSystem Administration Help AboutView Video ActiveX Mode Administrator has the authority to set the upload video View Image Java ModeInstall to the Web Server, and 2. install to your Local PC Function through the setting in the Upload option underStep Using IPView Pro with the Internet CameraInstallation Step Step Windows XP May shows incomplete screen when launching the program Getting StartedItem Feature DescriptionTo add a camera Using IPView ProAdding a Camera Removing a Camera Click Delete CameraViewing a Camera Recording Video Playing Recorded VideoConfiguring the System Camera Configuration Motion Configuration-1Motion Configuration-2 Tools Mailing Configuration Proxy Server Recording Configuration Schedule-Recording ConfigurationNS370 / NS370W User Guide YML814 Rev1 Others Log ListAccount Internet Camera Installation Appendix a Frequently Asked QuestionsInternet Camera Features NS370 / NS370W User Guide YML814 Rev1 Appendix B Ping Your IP Address Why does the Power LED not light up constantly? Appendix C Trouble ShootingCannot access the Internet Camera from a web browser Why does the Link LED not light up properly?There is poor image quality, how can I improve the image? Noisy images occur how can I solve the problem?Dithering artifacts in the image There are no images available through the web browser?Appendix D Time Zone Table Appendix E Adjust Internet Camera Focus Web Configuration section for further detailsAppendix F Specification Appendix G Glossary of Terms Dhcp DNSISP HEXIeee NAT JavaLAN PingSnmp RarpSmtp ULP TCP/IPUDP UTPPair connection does not exceed 100 metres Appendix H Cable InformationRJ-45 Network Ports 10MbpsCross-Over Cabling Straight and crossover cable configurationStraight-Through Cabling Copyright Information Appendix I Registration and Warranty InformationContact Information Customer InformationProduct Warranty Limitations of Warranty
Top Page Image Contents